The 3 in. steel round gas vent top is a type B round fitting that helps prevent rain and debris from entering the vent. It is not for use with wood-burning applications. It is made of durable galvanized steel and die-formed for uniform sizing and a strong, easy-to-connect joint. This fitting is tested and UL listed for safety in accordance with nape standards.
- Warranty period is 15 years from the date of installation, when used for venting AGA listed category II, III or IV gas heating equipment or water heaters in residential appliances
- Metalizations gas vent fittings have been tested and listed per UL 441 for installation as a type B and B-W gas vents to be installed in single and multi-story buildings in accordance with the standards of the national fire protection association
- Top is used to protect from birds and weather
- Lifetime limited warranty
- Die-formed to assure uniform sizing for a strong, easy-to-connect joint
- Tested and listed per UL 441 for installation in single and multi-story buildings
- Inner liner is aluminum
- Check appliance installation instructions for details
- Industry best warranty contact Selkirk for details
Anonymous –
I like the overall design, but I think a little heavier material should be used to prevent bending or denting
Anonymous –
We have this on our water heater vent pipe and anytime we get more than 20 mph winds it blows out our pilot light to our water heater, and I have to get down on the floor to light our pilot light again and again. I am a Disabled Vet and I am tired of doing this all the time so I am looking for something that will not only keep water, debris, but to also keep the wind out!!!
Anonymous –
extended the exhaust on my home and capped off with this looks great and meets code
Anonymous –
With our house in New England, we have a few vents to help alleviate heat build up during the humid summer months. For the longest time, those vertical pipes weren’t capped off so we would see water in our basement from the Radon system and water damage on the ceiling below. These cap fittings were able to install nicely and snug. Nice design to have a tab to help adjust for a better fit with confidence it’ll withstand high winds. Very pleased.
Anonymous –
Used this item to cover our vent pipe for our house drains. Was easy to install and works great.
Anonymous –
The aluminum material is so flimsy on this product. The manufacturer should be embarrassed to produce such a piece of crap.
Anonymous –
Completed the whole installation and flue tested well with the cap.
Anonymous –
Cap took spray paint well. Easy replacement on water heater roof stack.
Anonymous –
Best option for replacement roof vents if they end up fitting.
Anonymous –
Great product…..old one came off……went to Loews and found a replacement
with no problem…..problem solved in a few minutes with out spending a fortune
Anonymous –
Fit perfectly on bathroom toilet vent pipe.
Anonymous –
B-vent cap perfect fit for double wall exhaust…just snap on and lock in place…job done quick and easy!
Anonymous –
The quality of the material and how it fit the project
nan –
It fit perfectly better than what i had before.
Anonymous –
After storm obtained galvanized cap fittings from local store and easily installed. GREAT
nan –
Water does get in there and drops onto pipe inside
Anonymous –
Fit was great. Metal is very thin gauge and flimsy.
Anonymous –
/so far it is working okay. Have not had it that long.
Anonymous –
Beware…not galvanized, all soft aluminum.won’t rust, but flimsy
Anonymous –
As others have stated, the description is misleading, this is not for a 6 inch pipe.
Anonymous –
The description states “Selkirk 6-in Dia Galvanized Cap Fittings” I went to pick it up and it was a 3″ and they didn’t have a 6″
Anonymous –
Just what I needed to keep animals, birds, and other things from getting inside the pvc pipes that were coming outside the house because of the new furnace. I highly recommend.
Anonymous –
the description states a 6in diameter cap. the item is actually for a 3-inch pipe.